EPOXY CONDUCTIVE PRIMER FOR ELECTRICITY DISSIPATION
|
PRODUCT NUMBER |
1098SD |
|
TYPE |
A two pack, high performance coating based on outstanding weather and chemicals resistant water-based resin, pigment and additives. |
|
USES |
Used for electronic factory, wafer foundry, fab, hospital, exactitude apparatuses room, computer room, powder factory, textile factory, solvent storage tank, and ammunition warehouse. |
|
CHARACTERISTICS |
1. Low VOC, applied for indoor and enclosed space construction. 2. Good conductivity and electrostatic dissipation. 3. Used with EP-19AS or No.1015AS. |
|
GLOSS |
Below semi-gloss |
|
COLOR |
Black |
|
MASS DENSITY |
Above 1.0 Kg/L (mixture) |
|
VISCOSITY |
55～65 KU (mixture) |
|
DRYING TIME |
Set-to-touch 2 hrs. Dry hard 10 hrs. Fully cured 14 days (25℃) |
|
OPTIMUM FILM THICKNESS |
Wet 300 microns Dry 100 microns |
|
THEORETICAL COVERAGE |
12.5 ㎡/Gal 3.3 ㎡/L 3.3 ㎡/Kg |
|
OVERCOATING INTERVALS |
Min. 14 hrs. |
|
MIXING RATIO |
Base：Hardener＝1：2（weight ratio） |
|
NON-VOLATILE CONTENT |
Above 35% (mixture) |
|
POT LIFE |
Above 1 hr. (mixture, 25℃) |
|
THINNER |
Tap water |
|
THINNING RATE |
0~5% (cleaning tools excluded) |
|
STORAGE SHELF LIFE |
Minimum 1 years under normal storage conditions. |
|
APPLICATION METHOD |
Airless Spray, Brush, Roller |
|
NOTE |
1. Adhered moisture, grease, dirt and dust on substrate must be removed thoroughly. 2. Mix base and hardener according to the mixing ratio and stir thoroughly. 3. Avoid applying the paint in rainy weather or relative humidity exceeded 85%. 4. Clean containers after painting. |
|
|
|
|
 |
|
|
|
